Skip to content
GTI.

Neural interfaces and robotic hands

Neuro-Hand

A low-cost prosthetic hand with fingertip sensing and a camera-based grasp classifier.

Neuro-Hand is a low-cost prosthetic hand project. It combines fingertip pressure sensing with a camera-based grasp classifier, so the hand can tell which kind of grasp is needed.

The classifier runs on a small embedded board in the hand itself, which keeps the system cheap and compact.

What it does

  • Fingertip pressure sensing
  • Camera-based recognition of tripod, power and pinch grasps
  • Runs on a small embedded board

Status: In development

Neuro-Hand

Gallery

The blue 3D-printed Neuro-Hand with its wiring on a table, shown to visitors at a school event.
The blue 3D-printed Neuro-Hand with its wiring on a table, shown to visitors at a school event.
Three students at the Komarovi stand looking at the Neuro-Hand prototype and its electronics.
Three students at the Komarovi stand looking at the Neuro-Hand prototype and its electronics.
The blue Neuro-Hand on a desk next to a laptop and the control electronics.
The blue Neuro-Hand on a desk next to a laptop and the control electronics.
An ESP32 board on a breadboard with a chip and resistors, part of the Neuro-Hand electronics.
An ESP32 board on a breadboard with a chip and resistors, part of the Neuro-Hand electronics.

Tools and apps

  • Grasp ClassifierA camera on the hand tells tripod, power and pinch grasps apart.In development

Collaborate with this venture

Tell us what you need. We reply by email and say plainly whether we can do it.